Change out starter

Tiny
ANONYMOUS
  • MEMBER
  • 2002 LEXUS ES 300
  • 100,124 MILES
Change out starter. After putting everything back together. The agent idles to all and stalls out. How to reset idle
Friday, December 7th, 2012 AT 10:18 PM

1 Reply

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
After disconnecting battery or replacing ECM, drive vehicle to enable ECM to relearn driveability.

IAC VALVE OPERATION
Remove throttle body. Remove IAC valve from throttle body. Check IAC valve position. IAC valve should be in half open position. See Fig. 36 . Connect IAC valve connector to IAC valve. Turn ignition on and observe IAC valve operation. IAC valve should move to fully closed, fully open and then to half open position within .5 seconds of turning ignition on. If IAC valve operation is not as specified, replace IAC valve and retest.

Stalling: https://www.2carpros.com/articles/engine-stalls

Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Friday, December 7th, 2012 AT 10:31 PM

Please login or register to post a reply.

Related Engine Stall While Driving Content

Is it Safe to Drive Check Engine Light?
VIDEO
Is it Safe to Drive Check Engine Light?
Instructional repair video
Engine Stalls While Driving
GUIDE
Engine Stalls While Driving
An engine that stalls while driving and then starts back up again, either immediately or after a short time is different from an engine that just wont start or if the...
VIEW MORE

Sponsored links