rough running

2002 JEEP LIBERTY
85,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
LINDAW
  • MEMBER
  • 4 POSTS
It's 3.7 v6 Jeep Liberty, We have replaced a cam senor, code 131, it seem to run hot. won't get over 2000 rpm, or shift, want to stall, runs rough
Nov 24, 2010 at 2:52 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
A po131 indicates bank 1 sensor 1 O2 sensor is shorted to ground. Check the wiring to the sensor first and make sure nothing is shorted, melted... If it is good, chances are the sensor is bad.
Nov 24, 2010 at 2:59 AM
Advertisement
Avatar
LINDAW
  • MEMBER
  • 4 POSTS
we took it to a place they put a computer on the jeep, it showed a code po340, p0320, p1391. we replaced one of the senors. But the car when it gets to 2000rpm, it won't shift,runs rough, wants to stall. I'm sorry we are getting information as it is given to us. all the help you can give us would be appreciated. Thanks
Nov 24, 2010 at 3:55 AM
Avatar
LINDAW
  • MEMBER
  • 4 POSTS
we took the car to a auto zone they hook a computer to it. It came back with codes of p0340, p1391, p0320, It still won't go pass 2000rpm, want shift, runs rough, wants to die. Any information would be appreciated. Thanks
Nov 24, 2010 at 3:58 AM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
•P0340 Camshaft Position (CMP) Sensor Circuit
•P0320 Ignition/Distributor Engine Speed Input Circuit Malfunction
•P1391 Wheel Speed Sensor 1 - G - Sensor Circuit Performance
Nov 24, 2010 at 2:29 PM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
I would recommend starting with the cranks sensor. Have it checked.
Nov 24, 2010 at 2:29 PM