Car jerking when shifting gears and knock sensor diagnosis

2002 HONDA ACCORD
79,000 MILES
Avatar
MIKE NGASH
  • MEMBER
  • 1 POST
Hi Have an automatic honda crv yr 2002 which jerks when shifting to gear 2. I recently changed the linear assembly solenoid sensor but the problem still persists. the check engine light is on and have replaced several knock sensors but the diagnosis is still the same ie 23-01 Knock sensor 1 no signal. kindly advise what could be the problem
Feb 28, 2012 at 11:26 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
A faulty knock sensor can cause erratic shifting due to the engine computer retarding the engine ignition timing.

Since the code is coming back after replacement o the part, you should be looking at tthe quality of the parts used and also the wiring.

After getting the MIL problem rectified, retest to see if the harsh shifting is present.
Feb 28, 2012 at 1:16 PM
Advertisement