windstar solid check engine light

85,100 MILES • FWD • AUTOMATIC
Avatar
MYKALSON
  • MEMBER
  • 1 POST
My 02 Ford Windstar's check engine light just came on solid. The manual says this can happen when there's water in the gas tank, the gas cap isn't replaced properly or if low quality fuel is used. The cap was fine, it we're on a trip and I fueled up at a random station on the highway. The weather's also been dipping below freezing. Should I try a fuel additive or just give it a while after refueling?
Nov 27, 2010 at 9:04 AM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Have the computer scanned for code/s-you have a problem within the engine management system that caused the CEL to turn on-This is your starting point of diagnosis,finding out what's going on.
Nov 27, 2010 at 9:08 AM
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,414 POSTS
The gas cap is just one new thing they added to a very long list of possibilities because so many people were leaving them loose causing fuel to evaporate into the atmosphere. Your mechanic will connect a scanner to read the stored diagnostic fault codes. That will lead him to the circuit or system with the problem, not necessarily the defective part. That is the starting point in the diagnostic procedure. There are so many things it could be, there are now three-digit fault codes instead of two-digit codes.

caradiodoc
Nov 27, 2010 at 9:12 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement