2002 Ford Windstar harmonic balancer pulley

2002 FORD WINDSTAR
106,000 MILES • 3.8L • V6 • FWD • AUTOMATIC
Avatar
JIMMYE1225
  • MEMBER
  • 1 POST
can you pull the one piece harmonic balancer pulley with the engine still in the van, I have to change the reluctor wheel?
Nov 19, 2015 at 10:27 AM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
yes you can you mayhave to remove a shield to do it. also replace crank seal.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Nov 19, 2015 at 12:18 PM
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
here's more if you need it. make sure to remove rh front wheel and disconnect abs sensor wire make sure to support vehicle on a jack stand the subframe has to be lowered 2" ut sealer on keyway when installing and torque on subframe is 65 ft lbs. crank pulley is 118 ftlbs.
Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Nov 19, 2015 at 12:24 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.