Fuel gauge reads between 1/2 and 1/3. Replaced fuel pump and sending unit. No blown fuses found.
Tuesday, July 1st, 2014 AT 1:41 PM
4 Replies
JACOBANDNICKOLAS
MECHANIC
109,885 POSTS
Did it do the same thing with the old pump? If so, have you checked grounds? Also, were the connectors clean and tight on the pump? If everything is good as far as ground and power and connectors, then either the body control module (BCM) or the gauge itself is bad.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, July 1st, 2014 AT 6:32 PM
LARRYW64
MEMBER
9 POSTS
Yes, after changing the pump it reads the same. All electrical connections looked clean & were tight fitting.
Larry
Was this
answer
helpful?
Yes
No
-1
Wednesday, July 2nd, 2014 AT 11:39 AM
LARRYW64
MEMBER
9 POSTS
Is there a way to check the gauge?
Was this
answer
helpful?
Yes
No
Wednesday, July 2nd, 2014 AT 11:40 AM
JACOBANDNICKOLAS
MECHANIC
109,885 POSTS
If all wiring is good, it is either a bad gauge or BCM.