Advertisement

why does my temp guage keep going in the red

Avatar
SLAYER88
  • MEMBER
  • 2 POSTS
i have a 2002 focus se my upper radiator hose blew and over heated. i replaced the hose and thermastat. the gauge keeps going in the red about 3 minutes after i start driving
Aug 27, 2011 at 12:50 AM
Advertisement
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,812 POSTS
Did you bleed the system?

Did you check if the cooling fans are working correctly?
Aug 27, 2011 at 7:15 AM
Advertisement
Avatar
SLAYER88
  • MEMBER
  • 2 POSTS
How do u bleed the system
Aug 27, 2011 at 8:47 AM
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,812 POSTS
When engine is cold, check the coolant level. If it is low, top up the coolant. Without closing the radiator cap, start engine and allow to idle for 3 to 5 minutes. If coolant level drops, top it up. Close radiatro cap and run engine for another 5 minutes and allow to cool down before checking the coolant level again.

If coolant level is correct, check the cooling fans operations. Note if the upper hose is very much hotter than the lower hose, if yes, tyhe thermostat could be faulty. New components does not guarantee that it is good. Lastly, have a test performed to check if the head gaskets are bad if the radiator cap seems to have a high pressure when removing with cold engine.
Aug 27, 2011 at 8:18 PM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle