how do we get power to the feul pump?

2002 FORD F-250
40,000 MILES
Avatar
AUZZIE707
  • MEMBER
  • 1 POST
Rolled truck on right side. We pulled it back up on wheels. Got truck to start but ran like it was running out of feul. Did some repairs started it drove it down the road started running badly and would just idle nothing else. It shut off and would not start back up. Found we had no power to feul pump and when you turn on the key you get no instroment lights on dash.All of the fuses are good. Wondering if it could be computer.
Dec 21, 2011 at 1:48 AM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Could be the ignition switch and do you hear the fuel pump for a few secs when you turn key on?
Dec 21, 2011 at 2:00 AM
Avatar
RIVERMIKERAT
  • ✓ASE Certified Mechanic
  • 6,110 POSTS
  • ASE Certified Mechanic
First off, don't roll it.
Check the fuel cut-off switch. See image.
Check the bi-fuel relay in the bi-fuel relay module at the left rear of the engine compartment.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Dec 21, 2011 at 2:02 AM
Avatar
RIVERMIKERAT
  • ✓ASE Certified Mechanic
  • 6,110 POSTS
  • ASE Certified Mechanic
Grr
Dec 21, 2011 at 2:03 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.