rear window regulator

2002 FORD EXPLORER
6 CYL • 4WD • AUTOMATIC
Avatar
OBDRUMBUM08
  • MEMBER
  • 1 POST
how do i replace rear window regulator?
Aug 1, 2011 at 6:44 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
FIXITMR
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 9,990 POSTS
did ya get it done?
Oct 20, 2011 at 3:39 PM
Advertisement
Avatar
DAN_K
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 213 POSTS
Remove the interior door panel and lower the window slightly. You will see 2 bolts that attach the glass to the regulator. Loosen these bolts and support the window in the raised position with masking tape over the top of the door frame. On the stamped metal interior door panel you will see the bolts that hold the window regulator in place. Remove these bolts, unplug the electrical connector for the power window motor and remove the window channel extension. It can be tricky to remove as the access hole is not large. Take caution and you should be fine.
Oct 20, 2011 at 5:49 PM