How do i remove the air bag to replace the heater cole
Mar 24, 2013 at 4:21 PM
2002 Dodge Neon Remove Air Bag Replace Heater Cole
2002 DODGE NEON
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
ASEMASTER6371
- ✓ASE Certified Mechanic
- 52,796 POSTS
REMOVAL
Non-deployed Module
When removing an airbag for any reason other than DEPLOYMENT.
1.Disconnect and isolate the battery negative cable.
2.Wait one minute for the reserve capacitor to discharge before removing non-deployed module.
3.Remove instrument panel top cover. Refer to Body Instrument Panel, Instrument panel Top Cover, Removal.
4.Remove three screws to glove box door and remove door from instrument panel.
Fig.15 Passenger Airbag Remove/Install
5.Remove three passenger airbag cover screws attaching cover to top of instrument panel.
6.Remove two passenger airbag cover screws attaching cover to front lower instrument panel.
7.Remove three airbag attaching nuts from the support structure.
8.Lift the airbag up until the wire connector is visible and disconnect the connector.
Non-deployed Module
When removing an airbag for any reason other than DEPLOYMENT.
1.Disconnect and isolate the battery negative cable.
2.Wait one minute for the reserve capacitor to discharge before removing non-deployed module.
3.Remove instrument panel top cover. Refer to Body Instrument Panel, Instrument panel Top Cover, Removal.
4.Remove three screws to glove box door and remove door from instrument panel.
Fig.15 Passenger Airbag Remove/Install
5.Remove three passenger airbag cover screws attaching cover to top of instrument panel.
6.Remove two passenger airbag cover screws attaching cover to front lower instrument panel.
7.Remove three airbag attaching nuts from the support structure.
8.Lift the airbag up until the wire connector is visible and disconnect the connector.
Mar 24, 2013 at 8:46 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.