camshaft,crankshaft sensors

2002 DODGE INTREPID
150,000 MILES • 2WD • AUTOMATIC
Avatar
FAUTHERTYME
  • MEMBER
  • 1 POST
i have a 2002 Dodge Intrepid 2.7.I've replaced camshaft and crankshaft position sensors but computer still codes out "faulty sensors". I'm wondering if there was some process missed during installation.Unable to go faster than 70mph or to make sudden speed increses motor just shuts down until i release the gas pedal a little
Mar 10, 2011 at 12:34 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
What was the actual code? I wouldn't replace any sensor without, at least, checking ref voltage-- ground-- signal at the sensor.

Some sensors can share ref voltage and ground with other circuits.
Jun 9, 2011 at 11:13 PM
Advertisement