2002 Dodge Caravan no start

100,000 MILES
Avatar
MALAHIDE66
  • MEMBER
  • 3 POSTS
OK..parked came out next morning no start..no turning over. battery good. all relays tested good.. all fuses good.. replaced starter..and ignition switch..all according to a "friend" who is a mechanic. put on scanner got no codes at all.. not a high end scanner ..cheap one from auto-zone.. jumped out starter relay wants to turn over but wont..jumped out fuel pump relay it comes on...when i turn the key it does nothing i can hear a relay clicking but nothing..almost like dead battery.all other functions work..lights,radio,wipers,heater blower etc..there is no security system and have original keys..believe it or not this is in mint shape and dont want to get rid of it but am at a loss. any help would be great.
Jun 30, 2013 at 1:47 AM
Advertisement
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
I looked at the 3.3L engine. Any testing, make sure tranny is in park or neutral and parking brake is set. Terminal 30 at the starter relay should be hot all the time. If you jump terminal 30 to terminal 87, the starter should crank. If not check voltage at starter. red wire is hot all the time. The yellow wire with gray tracer should go hot when you crank it.

Jun 30, 2013 at 2:36 AM
Avatar
MALAHIDE66
  • MEMBER
  • 3 POSTS
i've already jumped out, relay cranks but wont start
Jun 30, 2013 at 2:57 AM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Check voltage at the starter.
Jun 30, 2013 at 3:15 AM
Avatar
MALAHIDE66
  • MEMBER
  • 3 POSTS
sorry already did.. have volts at starter
Jun 30, 2013 at 3:35 AM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
There are two circuits at the starter, both have to be hot with key in the crank position. How many volts? Also check the starter ground, usually grounds through starter housing and engine block.

If you have good voltage at both terminals on the starter and you have a good ground, then either the starter is faulty or the engine is seized. Can't be anything else.

You could pull the belt and spark plugs, then see if it will crank. Maybe hydro-static lock/fluid in the cylinder?
Jun 30, 2013 at 5:38 AM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Just to add, are you sure the battery has a full charge and battery connections all clean and tight?
Jun 30, 2013 at 6:09 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement