no 12 volt signal to ignition coil

2002 CHRYSLER SEBRING
125,000 MILES
Avatar
BILLY C
  • MEMBER
  • 21 POSTS
Help needed 2002 Chrysler sebring no 12 volt signal to ignition coil have installed new cam & crank sensors new ignition switch used computer.checked with mt2500 scanner cranking over engine I get Dis-cam&crank Cam-present Crank-present Asd relay-on Fuel pump relay-on Current-lost. Any Chrysler experts out there?
Feb 4, 2012 at 3:15 PM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Have you tested the ASD relay? Also any of the major sensors can short and cause the engine to not pulse. Disconnect all O2 and tps sensors to retry.
Feb 4, 2012 at 4:33 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.