2002 Chrysler Pt Cruiser Car Running Brought 3000 Rpms Stalls Could

98,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
when the car is running and is brought to 3000 rpms, it stalls. What could it be?
Mar 16, 2013 at 8:47 AM
Advertisement
Avatar
MR.J.CORNISH
  • MEMBER
  • 3 POSTS
I have a 2005 non-turbo Touring that does the same thing (and has for the past 2 months...) When the car is cold, it starts slowly and when driving, it will accelerate to 2500rpm, buck, rumble, stall, then up-shift. I can't drive any faster than 60mph without stalling. Sometimes, it will randomly cutoff while driving in traffic (sometimes at highway speeds!); it might restart in neutral (if I'm fast enough), then it might not. When it's warmed up, if you turn it off, it won't restart for about 35-45 minutes.

I've already spent over $500 replacing various sensors and parts, but after much research, investigation and grease time, I figured out that the problem is due to a bad signal from the camshaft position sensor (from a faulty wire from that sensor to the PCM), causing the 2500-rpm rev limiter built into the PCM to activate (to save the engine from presumed damage).

So after speaking to 9 mechanics, 3 dealership service departments, looking at over a hundred website articles and replacing all this: battery, spark plugs/wires, catalytic converter, starter, camshaft sensor (twice), crankshaft sensor, manifold absolute pressure sensor (twice), intake air temperature sensor, knock sensor, coolant temperature sensor, transmission input speed sensor, transmission output speed sensor, the problem looks to be a shorted wire to an $30 sensor.

Go figure...
Mar 21, 2013 at 9:49 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle