2002 Chevrolet Trailblazer lower ball join removal

2002 CHEVROLET TRAILBLAZER
85,000 MILES • 4.2L • 6 CYL • 2WD • AUTOMATIC
Avatar
RICKY1023
  • MEMBER
  • 1 POST
Im having trouble removing ball joint on the control arm. Also what is the torque on power steering lines on the rack n pinion
Nov 28, 2014 at 6:20 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JOHNNYT73
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 924 POSTS
There is a flange around the top of the ball joint that needs to be chiseled off before you try to start pressing it out. Are you using a ball joint press? From what I can find its about 18 ft-lbs on the steering line to steering pump. Honestly you really dont need to be concerned about the torque spec on the lines.Just be sure to replace the o-rings, and tighten them down snug. After you start the truck you can inspect for leaks.
Nov 29, 2014 at 4:49 AM
Advertisement