SPONSORED LINKS

S-10 clutch slave cylinder

Tiny
BSTORY25
  • MEMBER
  • 2002 CHEVROLET S-10
  • 4 CYL
  • 2WD
  • MANUAL
  • 160,000 MILES
How can I make my clutch slave cylinder build pressure after replacing it on my 2002 s-10? It has been bled and no air is in the system.
Friday, November 12th, 2010 AT 9:25 AM

2 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Inspect and test the clutch master cylinder the pressure starts there-could be leaking internally
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Friday, November 12th, 2010 AT 9:35 AM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
Bleeding these systems is no easy task due to the fact that the bleeder is at the bottom and the air rises to the top. It often requires using a pressure bleeder to get all the air out.
Was this
answer
helpful?
Yes
No
+1
Friday, November 12th, 2010 AT 1:49 PM

Please login or register to post a reply.

Related Transmission Clutch Slave Cylinder Replace/Remove Content

Throwout Bearing - Secondary Cylinder Replacement
GUIDE
Throwout Bearing - Secondary Cylinder Replacement
A throwout bearing/secondary cylinder is used to apply force against the clutch pressure plate to release the clutch disc and should be replaced as part of the normal clutch...
VIEW MORE

Sponsored links