2002 Chevy Cavalier Vehicle Speed Sensor

MUSTANG67MH

MEMBER
2002 CHEVROLET CAVALIER
4 CYL
AUTOMATIC
212,000 MILES

Where is it and how do I replace it?

Tuesday, May 17th, 2011 AT 1:12 PM

7 Replies

DOCFIXIT

MECHANIC
18,828 POSTS

Need to reply to original post or Tech will not see your post

SPONSORED LINKS

Was this

answer

helpful?

Yes

Sunday, March 15th, 2020 AT 8:14 PM

JACKJACK9

MEMBER
3 POSTS

Thanks on the picture very helpful. By any chance would you know how to get to the bad boy?

Was this

answer

helpful?

Yes

Sunday, March 15th, 2020 AT 11:43 PM

JACOBANDNICKOLAS

MECHANIC
109,885 POSTS

The sensor is internal. It requires removal of the side cover on the transmission. If I recall, the engine / trans needs lowered. Do me a favor, (it has been a long time since I dealt with one of these) see if you can remove the side pan from the transmission. If you can without lowering everything, it will be easy. If not, then you basically need to darn near remove the trans. If you look at pic 3, it shows where behind the pan the sensor is located.

2002 Chevrolet Cavalier L4-2.2L VIN 4
22. Input Speed Sensor Removal
Vehicle Transmission and Drivetrain Automatic Transmission/Transaxle Service and Repair Overhaul 4T40-E/4T45-E Automatic Transaxle Repair Instructions 22. Input Speed Sensor Removal
22. INPUT SPEED SENSOR REMOVAL

pic 1

1. Remove the wiring harness connector at the input speed sensor (46).
2. Remove the input speed sensor bolt (15) and the input speed sensor (46).
3. Remove the wire retainer clip bolt (15) and retainer clip.

_____________________

2002 Chevrolet Cavalier L4-2.2L VIN 4
85. Input Speed Sensor Installation
Vehicle Transmission and Drivetrain Automatic Transmission/Transaxle Service and Repair Overhaul 4T40-E/4T45-E Automatic Transaxle Repair Instructions 85. Input Speed Sensor Installation
85. INPUT SPEED SENSOR INSTALLATION
Important:
The tab on the sensor housing (46) fits into the recess on the case boss.
For drive sprockets with 35 teeth, use a black sensor housing. For drive sprockets with 32 or 33 teeth, use a natural colored sensor housing.

Pic 2

1. Assemble the input speed sensor (46) to the transmission case (51).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the input speed sensor bolt (15). Hand start the bolts.
Tighten the input speed sensor bolt to 12 Nm (9 ft. Lbs.).
3. Route the input speed sensor wiring harness in the case channel.
4. Connect the input speed sensor connector to the input speed sensor.
5. Install the wire harness retainer and wire harness retainer bolt.
Tighten the wire harness retainer bolt to 12 Nm (9 ft. Lbs.).

________________________

Let me know.
Joe

Image (Click to make bigger)