SPONSORED LINKS

Anti theft reset

Tiny
ZIGGYBOB
  • MEMBER
  • 2001 SATURN SL1
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 85,500 MILES
I need the procedure to reset the the anti theft after replacing the bcm
Saturday, April 9th, 2011 AT 9:08 PM

6 Replies

Tiny
PROTECH1980
  • MEMBER
  • 901 POSTS
Hello

Here are instructions for resetting the alarm.

1.Turn the ignition off for 1 minute.

2.Crank the engine and return the ignition to the run position for at least 10 minutes, but not more than 11 minutes. Go by the clock.

3. Turn the ignition off for 10 seconds.

4. Repeat steps 2 through 4 two more times.

5. Start the engine.

This guide can help as well

https://www.2carpros.com/articles/how-to-reset-a-security-system

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+7
Saturday, April 9th, 2011 AT 9:23 PM
Tiny
ZIGGYBOB
  • MEMBER
  • 2 POSTS
PROTECH 1980, Thank you for the info on my saturn. That fixed my problem, at least the car will start now. Is it possible to communicate with you further? I still can't keep the horn from sounding when I open the doors even though they are not locked.
Thanks again, zigybob
Was this
answer
helpful?
Yes
No
+4
Monday, April 11th, 2011 AT 5:15 PM
Tiny
BUX411
  • MEMBER
  • 0 POST
I ended up having to replace the driver side door latch cost me $78.00 for the latch all fixed FYI
Was this
answer
helpful?
Yes
No
-2
Monday, September 17th, 2018 AT 2:19 PM
Tiny
VALENCIO81
  • MEMBER
  • 1 POST
  • 2000 SATURN SL1
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 15,000 MILES
Hello, I have recently purchased the vehicle, the problem is I need to find the anti theft button;i have already changed the steering column and the car still won't let me start. It tries and starts but then dies please help! Thankyou, melissa lopez
Was this
answer
helpful?
Yes
No
+2
Monday, September 17th, 2018 AT 2:20 PM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Let's try this it will relearn your passlock sensor. Make sure your battery is fully charged up. Put your e-brake on so it will turn ur daytime running lights off. Also make sure your headlights blower fan and all that are off too. Now turn your key to the start position for a couple of seconds then let it go back to the run position dont turn to acc or off. You will see the security light ethier flashing or staying on solid if its on solid then wait till it turns off. If its flashing then wait till it turns solid or turns off. It will be about 10 mins between each light change of state. After it changes like I said then turn the ignition to the off position but not before or you will have to start over. Then wait 30 seconds then do it again you will have to do this 3 times after the 3rd cycle is done when you go to turn it to the start position for the 4th time it should start. Let me know if it starts.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+7
Monday, September 17th, 2018 AT 2:20 PM (Merged)
Tiny
VALLEJO14Z
  • MEMBER
  • 6 POSTS
Thanks for this post worked perfect for me
Was this
answer
helpful?
Yes
No
+3
Monday, September 17th, 2018 AT 2:22 PM

Please login or register to post a reply.

Related Disarm Content

Sponsored links