2001 PONTIAC SUNFIRE
128,000 MILES
Avatar
CHRS5503
  • MEMBER
  • 15 POSTS
I can't get power to the starter when i turn the key to the crank position. I replaced the ignition switch and still got the same problem. I can start the car with the key in the on position when i jump the solenoid on the starter with a screwdriver and it runs and drives fine. This car has the 2.2 automatic and I've also tried to crank it in Neutral. Can you tell me what the problem is?
Dec 3, 2012 at 11:07 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Inspect and test the park and neutral switch-see below EWD

Image (Click to enlarge)
Attached Media
Dec 4, 2012 at 3:45 PM
Advertisement
Avatar
CHRS5503
  • MEMBER
  • 15 POSTS
I ended up finding the problem last night turns out the key cylinder wasn't turning far enough to fully engage the ignition switch. I disassembled the cylinder and there is a metal plate sitting ontop of about ten springs that was bent out of shape, so i bent it back to shape and glued it down and the problem is solved. The metal plate holds the springs down to create the resistance that holds the key in the cylinder, thanks for the help anyway though.
Dec 4, 2012 at 3:57 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
You're welcome and thanks for coming back with the fix-Good Luck
Dec 4, 2012 at 4:00 PM