2001 PONTIAC AZTEK
325,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Headlight bulbs are fine.Tried new bulbs.All four corner signal lights work fine. On auto light position low beams work. When signal lever switched to high beam, left headlight completely goes out,low nor high works. Right side ok. Switch to low and low beams come back on. At times while signaling right turn high beam indicator on dash lights up.Also at times while in high beam position high beam indicator flashes.Is this a signal stat issue?
Dec 17, 2012 at 2:20 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
check fuses in underhoodfuse box for high beams first it may be an operational thing when truning right like inadvertenly pullling switch up to do headlight flash
Dec 17, 2012 at 3:15 PM
Advertisement
Avatar
BLUE PANTS
  • MEMBER
  • 2 POSTS
Fuses ok. As for the inadvertent movement we operated the switch several more times being careful as to refrain from the push or pull of the switch and the high beam indicator lit up again after many attempts.
Dec 17, 2012 at 6:51 PM
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
thenit's probably a bad multi function switch(turn sig switch)
Dec 17, 2012 at 7:59 PM
Avatar
BLUE PANTS
  • MEMBER
  • 2 POSTS
I replaced the multi function switch and all quirks have stopped. Thanks for support . Ed
Dec 20, 2012 at 1:10 PM