how to change a power stering pump
Dec 15, 2012 at 1:11 PM
2001 Oldsmobile Aurora Change Power Stering Pump
2001 OLDSMOBILE AURORA
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
1. Disconnect negative battery cable. Remove serpentine belt. Place a drain pan under vehicle. Remove or reposition, as necessary, coolant reservoir and power steering pump pulley. See POWER STEERING
PUMP PULLEY.
2. Remove air cleaner housing, (if necessary). Remove pressure and return hoses from pump. On "W" and "G" bodies, remove fuel injector site shield. Remove ABS wiring harness and bracket (if equipped). On "C"
body remove right outer tie rod using Tie Rod Remover (J 24319 01). See OUTER TIE ROD. Remove pump mounting bolts. Remove pump.
3. To install, reverse removal procedure. Fill and bleed hydraulic system. See HYDRAULIC SYSTEM BLEEDING under LUBRICATION.
PUMP PULLEY.
2. Remove air cleaner housing, (if necessary). Remove pressure and return hoses from pump. On "W" and "G" bodies, remove fuel injector site shield. Remove ABS wiring harness and bracket (if equipped). On "C"
body remove right outer tie rod using Tie Rod Remover (J 24319 01). See OUTER TIE ROD. Remove pump mounting bolts. Remove pump.
3. To install, reverse removal procedure. Fill and bleed hydraulic system. See HYDRAULIC SYSTEM BLEEDING under LUBRICATION.
Dec 15, 2012 at 4:26 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.