I own a 2001 mitsubishi montero, 3.56-6 cylinder engine.
I've replaced the heat sensors.
I've replaced the oxygen sensors.
I've replaced the front wheel speed sensor.
The engine was running well. as I drove quite a distance.
The next day, I start the engine and drive about 2 car lengths , when it stalls.
I was told to take off the negative pole from the battery to reboot the computer.
The following day, the engine will run only when I keep my foot on the gas.
Any Ideas on what I may do next to keep the engine from stalling?
I've replaced the heat sensors.
I've replaced the oxygen sensors.
I've replaced the front wheel speed sensor.
The engine was running well. as I drove quite a distance.
The next day, I start the engine and drive about 2 car lengths , when it stalls.
I was told to take off the negative pole from the battery to reboot the computer.
The following day, the engine will run only when I keep my foot on the gas.
Any Ideas on what I may do next to keep the engine from stalling?
Sep 17, 2011 at 1:24 PM
