Why seat belt light wont go off, all seat belts are connected?
Dec 31, 2012 at 4:15 PM
2001 Mazda Tribute Seat Belt Light Wont Off Belts Connected
2001 MAZDA TRIBUTE
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
KHLOW2008
- ✓ASE Certified Mechanic
- 41,814 POSTS
At least one of the seat belt buckle switch is faulty or you have a short in the wiring.
Jan 1, 2013 at 5:21 PM
I had this happen to me and it was a simple fix.
Look underneath the seat where the receiving end of the seat belt buckle fits into. Follow this down under the seat. You'll see and electrical connector in the wiring. Open this connector and using a cotton q tip dry the inside of this connector out. These connectors sometimes get moisture in them from condensation. One this connector is dry and clean snap it back together. The problem should be resolved.
Look underneath the seat where the receiving end of the seat belt buckle fits into. Follow this down under the seat. You'll see and electrical connector in the wiring. Open this connector and using a cotton q tip dry the inside of this connector out. These connectors sometimes get moisture in them from condensation. One this connector is dry and clean snap it back together. The problem should be resolved.
Nov 20, 2013 at 11:58 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.