shock absorbers

2001 MAZDA B3000
6 CYL • 2WD • AUTOMATIC
Avatar
GREG NACNAC
  • MEMBER
  • 1 POST
I have a 2001 Mazda B3000 and in the process of replacing the front shocks. My question is, do I need to make any adjustments to the torsion bar to install the new shock absorbers? I was told that the shocks I purchased is the correct one. I'm about 4-5 inches away from the bottom mounts.
Feb 11, 2011 at 1:40 AM
Advertisement
Avatar
KHLOW2008
  • ✓ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
No, you need not. The shocks are removed and installed by removing the upper and lower mounting nuts and bolts.

Did you compare the extended length of both new and old shocks?

Use a jack to lift up the lower control arm to enable the shocks to be installed.
Feb 22, 2011 at 4:39 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.