2001 Jeep Grand Cherokee lift kit

2001 JEEP GRAND CHEROKEE
174,000 MILES • 4.7L • V8 • 4WD • AUTOMATIC
Avatar
ACARLILE_86
  • MEMBER
  • 3 POSTS
I installed a 4" rusty's lift kit on my Grand Cherokee. Had a little trouble getting the pitman arm off because it was stuck and one rear lugnut had to be drilled out and stud had to be replaced. After get the lift kit installed and an alignment done it has an intense shake at about 35 mph. Do you know what might causing this?
May 8, 2015 at 8:24 AM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
more than likely because you put a lift kit in and didn't do the rest of the mods that is requires because your geometry is all out of whack even if it was aligned. got to PowerNation tv.com and type in death wobble in search they will explain it and how to correct it.
May 8, 2015 at 9:52 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.