how do you reset the check engine light now that the fuel sending unit has been replaced

2001 ISUZU RODEO
16,000 MILES
Avatar
GUYC911
  • MEMBER
  • 1 POST
replaced the sending unit and the pressure sensor on the fuel pump
Nov 3, 2011 at 12:48 AM
Advertisement
Avatar
MERLIN2021
  • ✓Experienced Mechanic
  • 17,250 POSTS
3 ways, reset with scan tool, rest by driving through the required drive cycle, or remove negative battery cable for a few minutes (not recommended).
Nov 3, 2011 at 5:10 AM
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,814 POSTS
If the light cannot reset, the problem has not been rectified.
Nov 3, 2011 at 7:48 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.