im installing the cylinder head to a 2001 hyundai elantra and i have the order to tightin the bolts but what is the torque that i have to stop at..
May 28, 2011 at 8:36 PM
installation
2001 HYUNDAI ELANTRA
BIGGMIKE
- MEMBER
- 58 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Step 1 18 ft.lbs.
Step 2 additional 60 degs.
Step 3 additional 60 degs
Step 2 additional 60 degs.
Step 3 additional 60 degs
May 28, 2011 at 8:43 PM
Advertisement
(1)Tighten in sequence with engine cold.
Image (Click to enlarge)
May 28, 2011 at 8:48 PM
i do 18 ft.lbs then 60?
May 28, 2011 at 9:19 PM
Doc were bouncing heads going somewhere? lol-didn't see you in there-sorry
When you're done with the 2nd 60deg angle-stop!
When you're done with the 2nd 60deg angle-stop!
May 28, 2011 at 9:32 PM
im having trouble installing my cam shaft can you please tell me how i can do it..thanks
May 29, 2011 at 4:38 PM
What kind of trouble see diagram it may help
Image (Click to enlarge)
May 30, 2011 at 5:55 PM
when i try to put the cam in it wont go in
the one side is in but the other side dont go all the way in
the one side is in but the other side dont go all the way in
May 30, 2011 at 7:53 PM
Install both cams at same time. place chain as in diagram. Cam csp with "L" are intake with "R" exhaust
Image (Click to enlarge)
May 30, 2011 at 8:09 PM