Hi,
When I select 'dash only' position on the vent selector knob something behind the dash starts clicking (about 2 per second). If I select a dash vent/floor vent mix (10 o'clock on selector knob or second position) there is no clicking. I removed one of the actuators (passenger side near center console and inboard of the motor and filter) opened it up and found no visible issues. I closed it back up and reinstalled it. I previously could not change vent position and didn't get air out of any vents but after reinstalling actuator I get air out of selected vents but clicking continues in the dash vent only position. Also if I have outside air selected and vent select knob in any of the defrost positions and I try to switch from outside to recirc, the recirc light ion button flashes and stays in outside air. That doesn't happen with other vent positions selected. Do I need to reset the HVAC system? I have read online that sometimes that corrects these types of problems but cannot find the reset procedures. Thanks for any help you can provide. You guys are awesome!
When I select 'dash only' position on the vent selector knob something behind the dash starts clicking (about 2 per second). If I select a dash vent/floor vent mix (10 o'clock on selector knob or second position) there is no clicking. I removed one of the actuators (passenger side near center console and inboard of the motor and filter) opened it up and found no visible issues. I closed it back up and reinstalled it. I previously could not change vent position and didn't get air out of any vents but after reinstalling actuator I get air out of selected vents but clicking continues in the dash vent only position. Also if I have outside air selected and vent select knob in any of the defrost positions and I try to switch from outside to recirc, the recirc light ion button flashes and stays in outside air. That doesn't happen with other vent positions selected. Do I need to reset the HVAC system? I have read online that sometimes that corrects these types of problems but cannot find the reset procedures. Thanks for any help you can provide. You guys are awesome!
Oct 29, 2014 at 12:15 PM
