The pedal gets a lot of slack and will not disengage the clutch

2001 FORD RANGER
142,000 MILES
Avatar
ICEMAN240
  • MEMBER
  • 2 POSTS
Every time it gets cold out my clutch stops working right. The pedal gets a lot of slack and will not disengage the clutch. I have to start it in gear and it will not shift right. There is some air getting in to the line.
Oct 15, 2011 at 10:22 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 31,937 POSTS
Check the master for any signs of leaking under the rubber boot where the push pod enters, if there is any signs of fluid there or the slave replace them.
May 4, 2021 at 10:14 AM
Advertisement
Avatar
ICEMAN240
  • MEMBER
  • 2 POSTS
I did have to add fluid. Ican not find a leak but the slave sleeve is inside the bell housing. Also there isn't a push rod at the master.I am grasping at straws here. Thanks for your help.
May 4, 2021 at 10:14 AM
Avatar
MHPAUTOS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 31,937 POSTS
Check master cylinder, there is a rod that attaches to the pedal, check under the rubber boot see pic for view.
Image (Click to enlarge)
Attached Media
May 4, 2021 at 10:14 AM