rod knocking

2001 FORD FOCUS
FWD • AUTOMATIC
Avatar
GRADYLATHAM
  • MEMBER
  • 2 POSTS
i replaced the crankshaft, rod and main bearings, had the block align bored. i put everything back together according to the book and now the # 1 rod is knocking. any help would be nice
Mar 21, 2011 at 3:45 PM
Advertisement
Avatar
FIXITMR
  • ✓ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
must not be getting enough oil either pressure is off or there is a passage blockage or the parts are out of spec.
Mar 21, 2011 at 3:51 PM
Avatar
FIXITMR
  • ✓ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
are you sure it's a rod knock? the bearing should show the results of the knocking?
Mar 21, 2011 at 3:52 PM
Avatar
GRADYLATHAM
  • MEMBER
  • 2 POSTS
getting ready to pull oil pan to check. i may have used the old rod cap.....
Mar 21, 2011 at 4:17 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.