bleeding car brakes

2001 FORD FOCUS
100,000 MILES
Avatar
AYRECHRIS
  • MEMBER
  • 1 POST
i can not get the air out of my front passenger brakes and my rear driver side but front driver side and rear passenger are ok
Jun 26, 2011 at 4:52 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 75,992 POSTS
If it has an ABS unit-you bleed the master and then the ABS then the wheels-You might need a scantool for the ABS unit
Mar 15, 2021 at 7:22 PM
Advertisement
Avatar
CADIEMAN
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 3,544 POSTS
gravity bleed the system.remove the cap on the master cylinder.start in the r/r open the bleeder.just let it drip youll see bubbles when you see constant dripping tighten the bleeder. same with the others l/r then r/f then l/f. make sure the master cylinder stays full.see ya
Mar 15, 2021 at 7:22 PM
Avatar
SQM
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 6,383 POSTS
Here is a helpful guide on how to bleed the brakes:

https://www.2carpros.com/articles/how-to-bleed-or-flush-a-car-brake-system

I have attached the vehicle specific brake bleeding round the meta hop.

Please let me know of any questions.
Thank you.
Image (Click to enlarge)
Attached Media
Oct 12, 2021 at 10:31 PM