Where do I find the explanation for the following codes P1101, p1132, p1138, p1151, p1157, p1408? Please advise. Thank you.
Jan 23, 2011 at 4:31 PM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
This message to WRENCHTECH Thank you. FYI all the above led to clogged passenger side catilytic converter, blown intake manifold gasket area of number two cylinder, and 5 to 8 lbs of vacume pressure. Pulled cat, runs fine, great vac pressure. Two thumbs up buddy.
Jan 23, 2011 at 7:17 PM
WRENCHTECH
AUTOMOTIVE REPAIR CONTRIBUTOR
20,761 POSTS
That was pretty good diagnostic work to find that. Good job.
Jan 23, 2011 at 7:20 PM
WISHIS
MEMBER
4 POSTS
I started to take the pats to quick. Pulled pipe off drivers side converter and its sucking air not blowing. I really have a hard time believing it jumped timing.
Jan 23, 2011 at 9:38 PM
WRENCHTECH
AUTOMOTIVE REPAIR CONTRIBUTOR
20,761 POSTS
Take a compression test.
Jan 23, 2011 at 9:56 PM
WISHIS
MEMBER
4 POSTS
Thank you, I'll try that. To cold tonight, will attempt tomorrow. Thanks for everything.