Turn signal flasher relay location?

2001 FORD EXPEDITION
160,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Where is the "flasher relay", I think that's what it's called, located under the dash of my SUV listed above? It is supposed to control the turn signals and the hazard lights?
Dec 17, 2012 at 11:30 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
My info says behind center of dash. Blower/flasher relay block. Please check the image below.
Image (Click to enlarge)
Attached Media
Dec 18, 2012 at 12:21 AM
Advertisement
Avatar
JAHVAIN
  • MEMBER
  • 1 POST
01 expedition.. Turn signals don't work or flashers turn signal starts to working then stop.. Heat works but not hot
May 18, 2020 at 6:29 PM (Merged)
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
pull hvac fuse inside car with key on that may allow actuators to reset. check item in pic then check to see if power goes through multi function switch arrow shows input and outputs
Images (Click to enlarge)
Attached Media
Attached Media
May 18, 2020 at 6:30 PM (Merged)
Avatar
DAAJAS
  • MEMBER
  • 2 POSTS
I replaced my flasher unit, and my signal lights still blink 1-2 times then nothing. My hazards and brake lights work fine. I push the signal arm down and it blinks 1-2 times then stops, it even clicks back into its normal position after I make a turn. Left or right does the same thing. My brake lights work and so do my hazard lights and windshield wipers. All bulbs are working also.
May 18, 2020 at 6:30 PM (Merged)
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
cold be a bad ground for flasher or the turn sign al swith may be going bad. check fuse 1 and 23 in central junction box then if you have atrailer wiring then check to see if there isn't a bare spot or wire rubbed through causing the problem.
May 18, 2020 at 6:30 PM (Merged)
Avatar
DAAJAS
  • MEMBER
  • 2 POSTS
Thank you. I'll check as soon as I can. I'll let you know what I find
May 18, 2020 at 6:30 PM (Merged)