2001 Dodge Truck Transmission

Tiny
MARLOWK
  • MEMBER
  • 2001 DODGE TRUCK
  • 5.2L
  • V8
  • 4WD
  • AUTOMATIC
  • 173,350 MILES
Whenever I put my truck in drive, it does not move my engine just revs up. My RPMs go all the way up. And now it is beginning to stall but once I let off the gas it comes back up. All gears work except for drive, 2nd, and 1st.
Tuesday, January 6th, 2015 AT 4:53 PM

5 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
Is the trans fluid clean and full? Is the check engine light on?
Was this
answer
helpful?
Yes
No
Wednesday, January 7th, 2015 AT 5:27 AM
Tiny
MARLOWK
  • MEMBER
  • 3 POSTS
Yes just filled tranny oil up yesterday. And yes it is. I also scanned it and the scanner said it was some type of evaporation leak.
Was this
answer
helpful?
Yes
No
Wednesday, January 7th, 2015 AT 5:32 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
Okay, the EVAP code isn't related. However, I question if you have a scanner to read trans codes. I have to be honest, if this is the original transmission, it most likely needs rebuilt. Other than that, does the gear indicator show you are in the correct gear? If you place it in 1st gear, is there any difference?
Was this
answer
helpful?
Yes
No
Wednesday, January 7th, 2015 AT 5:38 AM
Tiny
MARLOWK
  • MEMBER
  • 3 POSTS
Umm tbh I do not know if it the original transmission. I believe so. And yes all gears go in fine and it shows I'm in the correct gear.
Was this
answer
helpful?
Yes
No
Wednesday, January 7th, 2015 AT 5:44 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
At this point, you need to have the computer scanned with a scanner which can read transmission codes.
Was this
answer
helpful?
Yes
No
Wednesday, January 7th, 2015 AT 8:39 AM

Please login or register to post a reply.

Sponsored links