Advertisement

2001 Chrysler Sebring water pump replacement

205,000 MILES • 2.7L • V6 • FWD • AUTOMATIC
Avatar
MRTALLHAMER
  • MEMBER
  • 2 POSTS
I feel like I am pretty well versed under the hood and have done a number of part replacements on various cars and engines. I am quite stumped on this one. PLEASE HELP. In the process of changing out the pump, i ran into one bolt on the timing belt cover that is a star head, of course it is the furthest top facing the passenger side closest to the fire wall. I at first tried allen wrench ( before i could see that it was star) then went to store with allen wrench to gauge the correct size, bought T30 and 40, 40 was too big and 30 too small. I am doing this work in parking lot, any suggestions?
Aug 30, 2014 at 11:32 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
check to see if there is junk in the hole where t wrench goes it's probably a 40 just has crap or rust in it.
May 29, 2020 at 3:45 AM
Advertisement
Avatar
MRTALLHAMER
  • MEMBER
  • 2 POSTS
Thanks, with camera phone, took several pictures, even magnified, nothing that should block the 40, anyway, went back up to AZ and purchased the universal wrench, "chisel" and took a few taps. upon further investigation, that star bolt was not intended to be there.

Got the timing chain cover off but I have not seen enough of an instruction on what to remove after that to enable me to get water pump off. (passenger side mounted under plate and driven off timing chain) it appears that you have to remove the heads to be able to get to the the upper chain guides.

I have given in and will have a mechanic do it.
May 29, 2020 at 3:45 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle