2001 Chrysler Sebring emissions

2001 CHRYSLER SEBRING
195,000 MILES • 2.7L • 6 CYL • FWD • AUTOMATIC
Avatar
DOMO8513
  • MEMBER
  • 1 POST
I got a p0443 on my sebring....i replaced the canister valve solenoid....i reset the computer with a scan tool but the light came back on like 3 minutes later and has stayed on....any suggestions
Apr 18, 2015 at 1:56 PM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,246 POSTS
Have you checked wiring to the solenoid? Most often, there is a problem with the harness. Check to make sure the solenoid is clicking when actuated. If it isn't, remove the plug and check for power with the key on. If there is power, run a jumper to ground to see if the solenoid clicks. If it does, then there is a ground issue. If there is no power, you need to start looking for broken wires, bad pins in the connector, corrosion...

Trace the wiring harness to see if there are any rub marks that could be causing a short or open circuit.
Apr 18, 2015 at 2:11 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle