SPONSORED LINKS

2001 Chrysler Sebring emissions

Tiny
DOMO8513
  • MEMBER
  • 2001 CHRYSLER SEBRING
  • 2.7L
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 195,000 MILES
I got a p0443 on my sebring.I replaced the canister valve solenoid.I reset the computer with a scan tool but the light came back on like 3 minutes later and has stayed on. Any suggestions
Saturday, April 18th, 2015 AT 8:56 PM

1 Reply

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,747 POSTS
Have you checked wiring to the solenoid? Most often, there is a problem with the harness. Check to make sure the solenoid is clicking when actuated. If it isn't, remove the plug and check for power with the key on. If there is power, run a jumper to ground to see if the solenoid clicks. If it does, then there is a ground issue. If there is no power, you need to start looking for broken wires, bad pins in the connector, corrosion.

Trace the wiring harness to see if there are any rub marks that could be causing a short or open circuit.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, April 18th, 2015 AT 9:11 PM

Please login or register to post a reply.

Related Emission Content

Emission System
GUIDE
Emission System
Emission control systems or EVAP system as there are called have been incorporated into automobiles to prevent pollution by limiting the amount of un-burnt and evaporated ...

Sponsored links