I have a 2.7 Liter engine on my car. How do you replace the water pump?
Mar 21, 2012 at 5:03 PM
2001 CHRYSLER CONCORDE
BIGMANBUD
- MEMBER
- 2 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
WATER PUMP
NOTE:Water pump bolts directly to engine block and uses an "O" ring at pump-to-block mating surfaces. DO NOT allow oil or grease to contact "O" ring. Pump cannot be rebuilt and is serviced as a unit.
Removal
Drain cooling system. Cover drive belts and/or pulleys to prevent contact with coolant. If coolant contacts belts and/or pulleys, flush both with clean water.
Open radiator drain located at lower right side of radiator. DO NOT use pliers to open radiator drain. Remove coolant pressure bottle cap and open air bleed valve located on water outlet connector at front of engine. See Fig. 2 . Remove primary timing chain. See PRIMARY TIMING CHAIN & SPROCKETS . Remove water pump bolts. Remove water pump and gasket.
NOTE:Water pump bolts directly to engine block and uses an "O" ring at pump-to-block mating surfaces. DO NOT allow oil or grease to contact "O" ring. Pump cannot be rebuilt and is serviced as a unit.
Removal
Drain cooling system. Cover drive belts and/or pulleys to prevent contact with coolant. If coolant contacts belts and/or pulleys, flush both with clean water.
Open radiator drain located at lower right side of radiator. DO NOT use pliers to open radiator drain. Remove coolant pressure bottle cap and open air bleed valve located on water outlet connector at front of engine. See Fig. 2 . Remove primary timing chain. See PRIMARY TIMING CHAIN & SPROCKETS . Remove water pump bolts. Remove water pump and gasket.
Mar 21, 2012 at 5:08 PM
Advertisement