2001 CHRYSLER CONCORDE
11,100 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
i HAVE A 2.7 ENGINE my car drives and the RPM will not shift it keeps going I have been driving this for a year now.the codes on the care are P0340,P0700,P0605.Can you help?
Mar 23, 2013 at 10:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
A year????? And the engine hasn't blown up? You have one of the really tough ones.

Code 700 means there's some other diagnostic fault code stored in the Transmission Computer. That will put it in "limp mode" where it stays in second gear to allow you to drive it slowly to a repair shop without needing a tow truck. 30 mph would be pushing it.

P0340 – Camshaft Position Sensor Circuit Malfunction
P0605 – Internal Control Module Read Only Memory ROM) Error

I don't even know where to start with the two engine fault codes. The first thing to do is have the code in the Transmission Computer read. That will require a full scanner; not the simple code readers used at many auto parts stores. Once we know what's causing it to go to limp mode we can make some informed decisions on how to proceed.
Mar 23, 2013 at 11:31 PM
Advertisement