replaced with all new stuff .and it keeps blowing right rear wheel cylinder. its like pressure is to high or something
Nov 6, 2015 at 6:39 AM
2001 Chevrolet Tracker rear wheel cylinder failing
2001 CHEVROLET TRACKER
EVANPAULL
- MEMBER
- 4 POSTS
Advertisement
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
check for worn brake shoes should be .125 thick or close to it or a worn out brake drum 8,74" max. if not that check for broken springs or shoes not returning to original position.
Nov 6, 2015 at 9:38 AM
Everything is brand new pads spring drums and there adjusted
Nov 6, 2015 at 9:46 AM
When you push pedal down it pops out wheel cylinder. Or if you pull parking brake lever
Nov 6, 2015 at 9:48 AM
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
t sounds like it's not adjusted correctly or what I've said in previous reply o rmaybe the shoes are installed incorrectly could also be wrong shoes as well.
Nov 6, 2015 at 10:00 AM
Everything is installed correctly and brand new. Could it be the lspv. Proportioning valve
Nov 6, 2015 at 10:02 AM
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
absolutely not it cold be a blockage in line to other side but not proportioning valve. recheck installation and make sure all springs and clips are hooked up correctly and brake shoes are seated correctly into slots so they can 't slip out.see pic. make sure spring holding two shoes to cylinder is not broken or weak.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Nov 6, 2015 at 10:53 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.