2001 Chevrolet S-10 Engine

Tiny
SHANE7224
  • MEMBER
  • 2001 CHEVROLET S-10
  • 150,000 MILES
I have a 2001 s10 2.2L and I've replaced the engine. When I start it up it sounds like a tractor. Don't think it is an exhaust leak I've checked that. Sounds like back pressure of some kind. Can you help?
Sunday, August 18th, 2013 AT 7:58 AM

10 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Check to see if you hooked up your secondary air system. Pump is on lower right front of engine compartment
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 8:10 AM
Tiny
SHANE7224
  • MEMBER
  • 6 POSTS
I'll check it, pretty sure I did, I'll double check.
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 8:29 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
It cold be a hose off for that system
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 8:40 AM
Tiny
SHANE7224
  • MEMBER
  • 6 POSTS
It's hooked up
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 8:40 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
I can't see it so can give no further advice. I don't know what you did
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 8:42 AM
Tiny
SHANE7224
  • MEMBER
  • 6 POSTS
Could the wrong exhaust manifold gasket cause this because that's where the air pump connects? I had to put the original exhaust manifold on the new engine and the gaskets are different.
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 8:57 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
It cold because you may have installed them backwards causing the problem. Or the old manifold isn't designed for the newer engine. Ws the newere engine the same as the one removed?
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 9:00 AM
Tiny
SHANE7224
  • MEMBER
  • 6 POSTS
Yes, except I had to change the exhaust manifold because the new engine didn't have the air pump hook ups on the manifold. I was looking at the gasket that came off the old engine, and it has reliefs in the gasket for the air pump hook ups, the one I left on was flat.
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 9:05 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Then try the one that has the releifsas long as it seals.
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 9:07 AM
Tiny
SHANE7224
  • MEMBER
  • 6 POSTS
I will and ill let you know.
Was this
answer
helpful?
Yes
No
Sunday, August 18th, 2013 AT 9:09 AM

Please login or register to post a reply.

Sponsored links