where is the oil pump switch on a 2001 chevy s10
Nov 21, 2010 at 4:15 PM
chevy s10
2001 CHEVROLET S-10
KENNETHCPOPE
- MEMBER
- 1 POST
Advertisement
RASMATAZ
- ✓ASE Certified Mechanic
- 75,992 POSTS
ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT
TOOLS REQUIRED
J 41712 Oil Pressure Switch Socket
REMOVAL PROCEDURE
IMPORTANT: Clean the area around the sensor and Distributor before removal. Do not allow debris to enter the engine.
Remove the distributor.
Disconnect the engine oil pressure sensor electrical connector.
Remove the engine oil pressure sensor using the J 41712.
IMPORTANT: Note the alignment of the engine oil pressure sensor fitting prior to removal.
Remove the engine oil pressure sensor fitting, if necessary.
TOOLS REQUIRED
J 41712 Oil Pressure Switch Socket
REMOVAL PROCEDURE
IMPORTANT: Clean the area around the sensor and Distributor before removal. Do not allow debris to enter the engine.
Remove the distributor.
Disconnect the engine oil pressure sensor electrical connector.
Remove the engine oil pressure sensor using the J 41712.
IMPORTANT: Note the alignment of the engine oil pressure sensor fitting prior to removal.
Remove the engine oil pressure sensor fitting, if necessary.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Nov 21, 2010 at 4:28 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.