Can I get a ignition switch wiring diagram for a 01 impala?
Oct 9, 2012 at 6:24 PM
Can I get a ignition switch wiring diagram for a 01 impala?
2001 CHEVROLET IMPALA
J.STIEG
- MEMBER
- 361 POSTS
Advertisement
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
Having trouble with the starter not turning the car over?If so turn the key to the start position if there is power the switch is good. Check out the images (Below). Please let us know what happens.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Oct 9, 2012 at 6:57 PM
Its fine right now but, but the failer is intermittent. Might be having problem with the "run voltage" as well. I will be checking it later.
Post ignition switch diagram if you would. Thanks
Post ignition switch diagram if you would. Thanks
Oct 9, 2012 at 9:05 PM
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
I will post the wire diagram in a little bit what i ment to say was the yellow wire from the ignition switch should have battery voltage when the key is in the start position.So the starter is inop when it wont start?Also does it happen more often when the engine is hot?Is the security light on solid or flashing when it wont start?
Oct 9, 2012 at 9:48 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.