The axle bearing/seal are bad I need to change them out.

Tiny
RBRACE
  • MEMBER
  • 2001 CHEVROLET BLAZER
  • 6 CYL
  • 4WD
  • MANUAL
  • 180,000 MILES
The axle bearing/seal are bad I need to change them out.
Tuesday, January 25th, 2011 AT 8:20 PM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
To replace an axle shaft, you need to pull the cover off the center, take the center pin out and shove the axle in to remove the "C" clip. pull the axle shaft out and use the tip to pull out the wheel bearing. reverse procedure to reassemble and refill the axle after replacing cover and gasket. This video shows the job being done on a similar car but the process is the same.

https://youtu.be/ytqXLSjHNm0

and

https://www.2carpros.com/articles/rear-axle-seal-replacement

Please run down these guides and report back.
Was this
answer
helpful?
Yes
No
-1
Tuesday, January 25th, 2011 AT 9:21 PM

Please login or register to post a reply.

Sponsored links