2001 Chevrolet Blazer Boy Having Heck Time Trying Get Timing Right Truck Will

2001 CHEVROLET BLAZER
78,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
ACCORD89
  • MEMBER
  • 12 POSTS
BOY I AM HAVING A HECK OF TIME TRYING TO GET THE TIMING RIGHT SO THE TRUCK WILL START...........I REMOVE THE DISTRIBUTOR AND THE ENGINE WERE MOVE NOW I CANT GET THE ROTER TO POINT TO THE 6 ON THE DISTRIBUTOR AND THE DIS WILL NOT SRT ALL THE WAY DOWN
Jan 21, 2013 at 11:04 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
Are you aligning the rotor with the number one cylinder plug wire and have the crank shaft on top dead center? As far as the distributor not seating fully, move the rotor back and forth and it should drop into place.
Jan 21, 2013 at 11:06 AM
Avatar
ACCORD89
  • MEMBER
  • 12 POSTS
are you talking about where the number 1 cylinder plug wire go in the cap on the out side or inside the cap
Jan 21, 2013 at 11:20 AM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
Yes, where the #1 cylinder plug wire goes. That should be set at the #1 plug wire and if you look at the harmonic balancer, you need to set it to TDC.
Jan 21, 2013 at 11:26 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle