How do i adjust my shift so it will engage?

2001 AUDI S4
90,000 MILES
Avatar
RANGERBERRY
  • MEMBER
  • 2 POSTS
Replaced a clutch on a 2001 S4 Audi, put everything back together, engine turns over but the car only has reverse. Not sure if i didnt space something right or what, just need to narrow it down so i dont have to rip the whole car apart again.

Help, im a poor soldier trying to fix his own problems
Nov 28, 2011 at 8:27 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
System hydraulic no adjustment. can adj. pedal freeplay see diagram gap 0.126 (3.2mm) will trans go into gears engine off? does it grind when attempting first? was pressure plate and bearing replaced? bleed system?
Nov 28, 2011 at 9:14 PM
Advertisement
Avatar
RANGERBERRY
  • MEMBER
  • 2 POSTS
pressure plate, bearing and fly wheel were replaced. Clutch did not need to be bled, any suggestions?
Nov 29, 2011 at 11:37 PM
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
What happens if put in first engine off then attempt to start?
Dec 3, 2011 at 5:34 PM