who to replace Crankshaft Position Sensor on a jetta 2000

2000 VOLKSWAGEN JETTA
198,000 MILES
Avatar
JAM1MORA
  • MEMBER
  • 1 POST
My car stop running Ignition crank engine turn but not running. I run OBD II and I getting PO341 and i believe that is the Crankshaft Position Sensor.
I don't now if i have to replace now or look for other problem an solution to this.
Can you Help me I will appreciated your input.
Thank you;
Juan
May 17, 2012 at 3:31 PM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Check/Test the CPS and also the wiring back to the computer if all checks out -think computer
May 17, 2012 at 3:33 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.