2000 Toyota Tundra rear end axle bearing replacement 2 wheel drive v8 without ABS

2000 TOYOTA TUNDRA

285,000 MILES • 4.7L • V8 • 2WD

CHROME HEADERS

MEMBER
1 POST
FOLLOW

I changed the rear hub bearing in my 2000 Toyota Tundra sr5 v8 when I put the axle back in. The wheel locks up while the other one spins do I need to change drive shaft are there other bearings in the differential. Or change the whole rear do you replace the drive axle ? what did I do wrong ?

Feb 10, 2015 at 7:05 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

HMAC300

CAR REPAIR CONTRIBUTOR
48,601 POSTS

torque of axle mounting is 50 ft lbs. measure backlash of axle shold be no larger than .028" pull brake drum off and see if axle will turn while in neutral not park. see if anything is binding it and not the brake. see pics.

Images (Click to enlarge)

Feb 11, 2015 at 5:57 AM