The timing belt broke while cranking the engine. Did I bend valves??? it is the 3.0liter V6 engine.
Jan 20, 2011 at 6:20 AM
2000 Saturn LW2 broken timing belt
2000 SATURN STATION WAGON
RIKB111
- MEMBER
- 2 POSTS
Advertisement
DOCHAGERTY
- ✓ASE Certified Mechanic
- 9,606 POSTS
Most certainly, yes there are bent valves. It is an interference motor.
Jan 20, 2011 at 6:30 AM
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
To add on this answer did the Timing belt tensioner fail?If so so will have to replace the tensioner with the new style one that requires you to replace the timing belt backing plate they sell a kit.Plus you have to address the possible bent valve's.I have seen it go both way's on those engine's bent and not bent depending on your luck and the postion of cam's when the belt let go.
Jan 20, 2011 at 4:45 PM
DOCHAGERTY
- ✓ASE Certified Mechanic
- 9,606 POSTS
It is always really great to have a REAL pro add their comments.
Jan 20, 2011 at 4:55 PM
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
Just pitching in to help out where i can.Hope you had a great holiday and happy new year DR Hagerty.
Jan 21, 2011 at 2:29 AM
DOCHAGERTY
- ✓ASE Certified Mechanic
- 9,606 POSTS
The same to you and all your loved ones, and I really do appriciate the words of wisdom for our Saturn wagon owner, hopefully their troubles will be few.
Jan 21, 2011 at 2:42 AM
Thanks for the input. I have decided to make a stab at replacing the timing belt (I will rent the special tools). I have replaced timing belts on simpler engines but was wasnt sure about the valve thing with this engine. It makes sense to me to try (I might get lucky), and if the valves are bent, then I will yank the engine and take my time fixing this. You guys helped me make my decision. Thanks.
Jan 21, 2011 at 4:57 AM
DOCHAGERTY
- ✓ASE Certified Mechanic
- 9,606 POSTS
Thank you for trusting us, and for letting us help with your decision.
Jan 21, 2011 at 7:44 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.