2000 PONTIAC SUNFIRE
150,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
The electric cooling fan isnt running on my 2000 Sunfire. i changed fan relay and temperature sensor located on top of the pipe conected to the top radiator hose and the fan fuse is good and the fan will run if hooked up directly to the battery ,. what could be causing this?
Dec 23, 2012 at 9:36 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
Did you check voltage and ground at the fan connector. You can use a jumper at the relay, to see if fan will run. Jumper goes between terminal 30 and 87, the fan should run. Did you check for voltage at the fuse circuit? Even if the fuse is good, if there is no voltage, the circuit is dead.
Image (Click to enlarge)
Attached Media
Dec 23, 2012 at 5:31 PM
Advertisement